3. Getting startedBarco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006 _____________________________________________________ 3-44After switching on the PROCESSOR boot information is displayed on the graphic device connected to port 0 of thefirst graphic card.When switching on the central Processor of a distributed system this text is displayed on theconnected monitor.The other displays show their respective bus and slot no., e. g.:PCI Bus: 2, PORT: 1There are two possible boot modes for T RANS FORM A. Normal boot mode and eXtended safety boot mode. Seesection 6.1.1 Boot modes. The operation of TRANS F ORM A differs a little, depending on this mode.Normal boot modeAfter a few minutes the graphical user interface X.11 appears without user interaction.eXtended safety boot modeThe TRANS FORM A startup screen comes up. Select linux to boot from the working partition.If you select backup, the restore procedure is started and the working partition becomesoverwritten with the backup system, which might lead to a loss of current data, dependingon the state of the backup, please see section 4.8.5 Backup and restore procedures (eosxs Utility)!Figure 3-54T RANSF ORM A startup screenAfter a few minutes the graphical user interface X.11 appears.ConfigurationIf software configuration has already been carried out you can go on with chapter 4 Operating. Otherwise proceedconfiguring TRANS FORM A in section 3.4 Configuration software.
