Barco NGS-D200 User Manual

Also see for NGS-D200: Quick start guide

Contents

Barco NGS-D200 User Manual Manual pdf 71 page image

Appendix II: Making a Simple Connection Between an NGS-D200 Encoder and DecoderAppendix II: Making a Simple ConnectionBetween an NGS-D200 Encoder and DecoderThis section outlines how to directly connect Standalone NGS-D200 encoders to decoders.II.1 Prerequisitesl Both systems are operating in "Standalone" modeII.2 Encoder Setup1. Launch a web browser. In the address bar, enter the IP address/domain name of the NGS-D200 unit (e.g. 10.1.5.50)2. Ensure the device is configured as an encoder and in "Standalone" mode. You will see this information on the top ofthe Web UI.l If the system is not, navigate to the Administration section of the pageo If not operating in Standalone Mode:n Under the Standalone Mode section, check the box.n At the bottom of the page, click "Apply"n Click "Save Settings"o If not an encoder:n Under the System Control section, click "Encoder/Decoder." The system will reboot andcome up as an encoderNOTE: After the system boots and you log back in, make sure to click "Save Settings"to ensure the device will continue to come up as an encoder after any subsequentreboots.TIP: You can configure the encoder streaming parameters by configuring theConnection Profile section of the page.For more information, see "Connection Profile"on page 28II.3 Decoder (client) Setup1. Launch a web browser. In the address bar, enter the IP address/domain name of the other NGS-D200 unit2. Ensure the device is configured as a decoder and in "Standalone" mode. You will see this information on the top ofthe Web UIl If the system is not, navigate to the Administration section of the page:o If not operating in Standalone Mode:n Under the Standalone Mode section, check the box.n At the bottom of the page, click "Apply"n Click "Save Settings"63 NGS-D200 User Guide