Chapter 4: Installation and Connections4.3.2 Decoder Local Mode DataflowFor workflow flexibility, the decoder can be operated in "Local" mode to enable users to operate the workstation (localsource PC) at their desk.Figure 4-2: The decoder operating in Local Mode4.3.2.1 Setting the Decoder to Local ModeVideo, audio and keyboard/mouse mode must be set to "Local" mode to pass the respective input back to the source.1. Video - Set the video to Local mode.For more information, see "Decoder Input Video Parameters" on page 452. Audio - Ensure the decoder audio mixer is appropriately configured.For more information, see "Audio MixerConfiguration" on page 513. Keyboard/Mouse - Set the keyboard/mouse mode to "Local" mode.For more information, see "DecoderKeyboard/Mouse Parameters" on page 564.4 Connections for 3D/Stereoscopic VideoNOTE: 3D/Stereoscopic video is only supported on the NGS-D200 Pro 3D. For information on upgrading to the Pro3D, please contact Barco Sales.This outlines a simple setup in which a single stereo source will be transmitted to the remote side.4.4.1 Tools and equipment requiredl 3D-visualization engine or other stereo video generating devicel Stereo emitter (with power cords)17 NGS-D200 User Guide
