Barco ICMP Installation Manual

Also see for ICMP: Service manual Installation manual

Barco ICMP Installation Manual Manual pdf 44 page image

A. Technical specificationsGPOut PGPOut PGPOut NGPOut NOutput from projector Internal projectorMax 120 mWR RMVACVAC V....V....Vmaxmax V+V+Image A-2When the GPO driver inside the projector becomes powerless the GPO state changesto the default state. The default GPO state depends on the external system connectedwith the GPO port (pull-up or pull-down circuitry).GPIO and projector Sleep modeIn case the projector is equipped with a “Sleep” mode (e.g. DP2K S series): Enter or leave Sleep modecan be done with GPIO of the Cinema Controller via two predefined Macros (not editable). Not with theGPIO of the ICMP.The GPO signals of the ICMP will return to their default output level when the projector is switched to Sleepmode. This could generate unexpected "Falling Edge" triggers at the output pins. Also when awakeningthe projector (from Sleep mode to Standby mode) the GPO signals of the ICMP may generate unexpected"Rising Edge" events.GPO and projector switching On or OffThe GPO signals of the Cinema Controller and ICMP will return to their default output level when theprojector is switched to power-off. This could generate unexpected "Falling Edge" triggers at the outputpins. Also during power-on the GPO signals may generate unexpected "Rising Edge" events.A.3 Pin configurations of the ICMP communication portsRJ-45 pin configurationP1P8Image A-3Audio Channels:AUDIO-AES 1-8Audio channel AES pair RJ-45 pin1 + 11, 21 - 22 + 33, 42 - 63 + 45, 63 - 540 R5905722 ICMP 09/11/2016