Banner iVu Plus TG Series Instruction Manual

Contents

Banner iVu Plus TG Series Instruction Manual Manual pdf 80 page image

13 Configuring SensorsEach sensor type has a parameters shortcut menu available from the inspection menu.From the Home screen, click inside the Region of Interest (ROI). The ROI is the visual area indicated by a dotted line on theinspection. In the Demo mode this is the Banner Engineering logo. The dotted line becomes bold and has rotation and sizeicons in the corners. At the top of the displayInspection Name changes to a black button calledSensor Name. Click SensorName and a dropdown list displays.Figure 98. Example Shortcut MenuNo matter what parameter you are setting, if you click inside the ROI it will highlight into a bold dotted line that can beresized.13.1 Setting the TriggerBy default, the Trigger is set to Internal, and will continuously trigger based on a time interval setting. This may make it moredifficult to make adjustments while setting up the iVu. The best practice is:1. Go to Main Menu > Imager > Trigger menu and select External.Figure 99. Trigger Screen2. Make sure there is no external trigger input.3. Use the Trigger icon in the lower-right of the display to manually trigger the iVu to capture an image as you set upand test.4. Capture images of a range of samples to set up from the "worst" good part to the "best" bad part.13.2 Configuring an Area Sensor1. Begin the setup with a good part.2. Center the part to be tested in the Field of View (FOV).3. Adjust the Region of Interest (ROI) so that it surrounds the feature of interest. In the Demo example, the feature ofinterest is the Banner logo. The ROI is red because the parameters need to be set.iVu Plus TG and Color Gen2 Image Sensors80 www.bannerengineering.com - Tel: + 1 888 373 6767