Banner iVu Plus TG Series Instruction Manual

Contents

Banner iVu Plus TG Series Instruction Manual Manual pdf 70 page image

Figure 83. Input Polarity Screen11.6.2 Input PullupMain Menu > System > Discrete I/O > Input PullupBy default, the Input Pullup is disabled. If the device used to trigger and remote teach the iVu is a NPN device, enable InputPullup here if that device does not have its own pullup resistor. Otherwise, this should be disabled.11.6.3 Output TypeMain Menu > System > Discrete I/O > Output TypeSelect NPN to configure the device's outputs to sink current. Select PNP to configure the device's output for sourcecurrent.11.6.4 Output 1, 2, and 3Main Menu > System > Discrete I/O > Output (#)Figure 84. Discrete I/O MenuOutput 1, 2, and 3 are set up separately to improve flexibility and simplicity.Output can be configured for Inspection Pass, Inspection Fail, Sensor Pass, Sensor Fail, Sort Pattern #1, Missed Trigger orSystem Error.A Missed Trigger condition occurs when a trigger is received while the iVu is busy inspecting the previous image. Thisoutput signal is set to active state. This signal will be reset up on resetting the History on the statistics screen.A System Error condition occurs when a fatal error is detected on the device. This output signal will be set to active state.This signal can be reset upon resetting the History on the statistics screen, or executing a ClearSystemError commandthrough command channel.The default setting is Inspection Pass and Latched for Output 1. If Pulsed is selected, the default Pulse width is 50 ms.Note: For Latched, the signal is active until the results of an inspection cause a change in the signaloutput.iVu Plus TG and Color Gen2 Image Sensors70 www.bannerengineering.com - Tel: + 1 888 373 6767