Banner Q5XKLAF2000-Q8 Instruction Manual

Also see for Q5X: Reference guide Quick start guide Instruction manual Quick start guide Quick start guide

Banner Q5XKLAF2000-Q8 Instruction Manual Manual pdf 13 page image

3.2.6 Gain and SensitivityUse this menu to set the excess gain mode. This menu is only available when a 15, 25, or 50 millisecond response speed isselected. It is not available for 3 or 5 millisecond response speeds.• —High excess gain mode• —Standard excess gain mode with increased noise immunity3.2.7 Output Timing DelaysUse this menu to select the output timing delay to be set. On and off delay timers can be used together. The default is nodelay. For Channel 2, this menu is available when the output is set to light operate or dark operate.Note: The number that follows dLY on the display indicates which channel is selected.• —No delay• —Delay—enables the selection of on and off delay timers• —One-shot—enables a one-shot, fixed output pulse duration• — Totalizer—enables an output after a defined number of targets are countedOutputOFF DelayON DelayTime1-ShotONOFFDDDDD D(D = 1ms - 90.0s)Figure 17. Output Timing DelaysWhen one of the timing delay options is chosen, the sensor returns to the Setup menu and additional options becomeavailable to set the parameter(s):• —On delay• —Off delay• / —One-shot delay timerNote: For the one-shot delay timer:• LO = On pulse when a target is detected inside of the switch point(s)• DO = On pulse when a target is detected outside of the switch point(s)• / —Output duration• / —Number of counts before an output changeQ5X Laser Triangulation Sensor with Background Suppressionwww.bannerengineering.com - Tel: +1.763.544.3164 13