Band-it Ultra-Lok UL4000 Operating Instructions Manual

Also see for Ultra-Lok UL4000: Clamping Instructions Clamping Instructions

Contents

Band-it Ultra-Lok UL4000 Operating Instructions Manual Manual pdf 3 page image

BAND-IT-IDEX, Inc.A Unit of IDEX Corporation4799 Dahlia StreetDenver, CO 80216-0307 USAP: 1-800-525-0758F: 1-800-624-3925Document # P07886 Rev. L© CopyrightBAND-IT-IDEX, Inc. 2010All rights reservedwww.BAND-IT-IDEX.comPage 3 of 14UL4000Ultra-Lok ToolSetupInstructionsUse only with BAND-IT ¾” and ½” Ultra-Lok Free-End and Preformed ClampsWarning:Always wear safety glasses when operating this tool. Keep both hands away from clamp being tensioned. Usecommon sense, squeezing force of ¾” clamp can reach as high as 2 tons. Never attempt to clamp objects whichcan shatter, or otherwise cause bodily harm.Gear SelectorDrillClutchTool BodyAdapterM07687DrillM09485 ( DC987,DC925, or equivalent)or M07087 (DW987)Tension Block PositionViewing Slot(also lubrication syringe access)ForwardReverseSelectorSwitchAdapter ClampM082881. Read safety instructions and operator‟s manual for the DeWalt DC987/DW987/DC925 cordless drill. Check to makesure drill is properly set up for use with Band-It Ultra-Lok tool as follows:-----Drill spindle has adapter clutch (Band-It #M21790) installed in place of standard drill chuck.-----Speed gear selector must be on number 1, and drill clutch torque setting as shown on page 5.2. Charge drill according to the operator‟s manual for the DeWalt cordless drill.3. To mount drill onto Band-It Ultra-Lok tool: First use the two #10-32 x 3/8” screws supplied with tool to tighten tooladapter body to the tool. With adapter clamp on tool adapter body, insert drill into back of tool through the adapterclamp. Turn drill manually to desired position in relation to tool. Press the drill firmly into tool. Actuate drill if necessaryto engage drill safety clutch (M21790) to tension screw. Tighten clamp screw while keeping the drill firmly pressedagainst the tool. To remove drill from tool: loosen the clamp screw and pull drill away from the tool.4. This tool was designed for, and can only be used with BAND-IT ¾” and ½” wide Ultra-Lok clamps. Do not attempt touse on any other type of clamp as it may damage tool. Only use ½” wide clamps when the optional ½” shear plate(BAND-IT #M09387) has been installed in the head in place of the ¾” shear plate.ToolHeadBandSlotAdapterClampTensionScrew