Band-it S03869 Operating Manual

Band-it S03869 Operating Manual Manual pdf 1 page image

BAND-IT-IDEX, Inc.A Unit of IDEX Corporation4799 Dahlia StreetDenver, CO 80216-3070 USAP: 1-800-525-0758F: 1-800-624-3925Document # PO6788 rev. D© CopyrightBAND-IT-IDEX, Inc. 2006All rights reservedwww.BAND-IT-IDEX.comPage 1 of 2S03869 - BAND-ITCenter Punch ToolOperatingManual1. Tool is designed specifically for 3/8” and 5/8”center punch clamps only. Insert clamp in tool andthen insert wrench assembly. If you prefer, installwrench assembly before clamp is inserted. Slot mustbe aligned with clamp tail.2. Start “pumping” ratchet wrench forward until propertension has been applied.3. Place punch on clamp and while holdingtension with ratchet wrench, lock clamp by strikingpunch once or more with hammer, depending onobject being clamped.4. While holding tension with wrench, pivot tool upagainst buckle, then backward several times tobreak off clamp tail.5. To loosen clamp tail, wind ratchet wrench untiltail is free. Remove ratchet wrench assembly andclamp tail. Caution: Clamp tail may spring backonce released from tool nose.

/ 2

Related manuals for Band-it S03869