TABLE OF FIGURESFigure 1: UHA[T][M][X][S]150 - 250 Label Placement ..............2Figure 2: UHA[T][M][X][S]300 - 400 Label Placement ..............3Figure 3: Installation Clearances and Clearances toCombustibles ..........................................................7Figure 4: Suspension Methods .................................................9Figure 5: Vent and Roof Detail ................................................ 12Figure 6: Standard Vented Heater - Vertical and HorizontalVent Termination.................................................... 13Figure 7: Standard Vented Heater - Common Vertical VentTermination .............................................................. 14Figure 8: Separated Combustion Heater - Vertical andHorizontal Vent Termination .................................. 15Figure 9: Concentric Vent Box................................................. 15Figure 10: Concentric Vertical and Horizontal VentTermination - Separated Combustion Heater ........ 16Figure 11: Gas Connection...................................................... 19Figure 12: Automatic Burner Control Sequence ......................30Figure 13: Single Stage Gas Valve for ModelsUHA[X][S] 150 - 400 .............................................31Figure 14: Two Stage Gas Valve for ModelsUHA[T][X][S] 150 - 400 .........................................31Figure 15: Modulating Gas Valve for ModelsUHA[M][X][S] 150 - 400 ........................................32Figure 16: LED Diagnostic Codes ...........................................36There are references in this manual to various trademarks. All trademarks mentioned herein, whether registered or not, are theproperty of their respective owners. Bananza is not sponsored by or affiliated with any of the trademark or registeredtrademark owners, and makes no representations about them, their owners, their products or services.
