BARRON Trace-Lite E110 Installation Instructions Manual

BARRON Trace-Lite E110 Installation Instructions Manual Manual pdf 1 page image

INSTALLATION INSTRUCTIONS800.533.3948 • www.barronltg.com11120070136 REV 2 - 02/19E110AAC CABCA - 1/2” NPS tapped holes (surface conduit or photo control).B - 3/4” dia. backplate access hole.C - 5/16” Mounting holdsScrewHousing Sealing ringGasketLeveling BubbleBackplateDriver location mayvary depending onthe modelIMPORTANT SAFEGUARDSREAD AND FOLLOW ALL SAFETY INSTRUCTIONS.When using electrical equipment, basic safety precautions should always be followed including the following:• DISCONNECT AC POWER SUPPLY BEFORE SERVICING.• Installation and servicing of this equipment should be performed by qualified service personnel only.• Ensure that the electrical wiring conforms to the National Electrical Code NEC® and local regulations if applicable.• Do not mount near gas or electric heaters.• Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering byunauthorized personnel.• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.• Any modification or use of non-original components will void the warranty and product liability.• Do not use this equipment for other than intended use.SAVE THESE INSTRUCTIONS!Junction box Mount1. Loosen screws and remove the front housing carefully from thebackplate (Fig. 1).2. Drill appropriate knockouts (B) for wiring. The fixture supports standard3 1/4'' and 4''J-box. (Fig. 2)Note: Do not rely solely on fasteners at the J-box.3. Drill out the mounting holes (C) from the backplate and secure to thewall with appropriate screws (hardware provided by others).Note: Use the supplied gasket for a weather tight seal.4. Connect the wires (See Wiring section)5. Replace the housing onto the backplate hinges, make connections,then close and tighten with screws.Conduit Mount1. Loosen screws and remove the front housing carefully from thebackplate.2. Remove 1/2” plug (A) for conduit feed.3. Drill out the mounting holes (C) from the backplate and secure to thewall with appropriate screws (hardware provided by others).Note: Use the supplied gasket for a weather tight seal.4. Connect the wires (See Wiring section).5. Replace the housing onto the hinges, make connections then close andtighten with screws.Note: Construction is suitable for downlight ONLY.Fig. 1Fig. 2

/ 2

Related manuals for BARRON Trace-Lite E110