BARRON Trace-Lite AXL2 Installation Instructions Manual

Also see for Trace-Lite AXL2: Installation instructions

Contents

installation instructions

BARRON Trace-Lite AXL2 Installation Instructions Manual Manual pdf 1 page image

AXL2 (15-50W)INSTALLATION INSTRUCTIONS800.533.3948 • www.barronltg.comKnuckle Mount 15W, 30W, 50W1. Feed wire lead from 1/2” NPT knuckle into weatherproof box cover or post top fitter, then secure threaded knuckleinto place.2. Electrical connections should be made at this time (see Wiring section).3. To adjust AXL2 angle loosen screw on the center of the knuckle, adjust to desired position and retighten screw.20070137 REV 1 P-9 - 2/19New imageIMPORTANT SAFEGUARDSREAD AND FOLLOW ALL SAFETY INSTRUCTIONS.When using electrical equipment, basic safety precautions should always be followed including the following:• DISCONNECT AC POWER SUPPLY BEFORE SERVICING.• Installation and servicing of this equipment should be performed by qualified service personnel only.• Ensure that the electrical wiring conforms to the National Electrical Code NEC® and local regulations if applicable.• Do not mount near gas or electric heaters.• Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering byunauthorized personnel.• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.• Any modification or use of non-original components will void the warranty and product liability.• Do not use this equipment for other than intended use.SAVE THESE INSTRUCTIONS!1

/ 2

Related manuals for BARRON Trace-Lite AXL2