Asus RP-AC53 Quick Start Manual

Also see for RP-AC53: Quick start guide Quick start guide

Quick Start GuideRP-AC53Dual-band Wireless RepeaterE11934Second EditionAugust 20161. Power LEDOn: RP-AC53 is plugged to a power outlet andpowered on.Off: RP-AC53 is unplugged from a poweroutlet or powered off.2. Etherenet LEDOn: Ethernet is connected.Off: Ethernet cable is disconnected.3. 2.4 GHz / 5 GHz Wi-Fi LEDGreen : Best 2.4 GHz / 5 GHz Wi-Fi Repeaterconnection with parent AP.Orange: Good 2.4 GHz / 5 GHz Wi-Fi repeaterconnection with parent AP.Red: Poor 2.4 GHz / 5 GHz Wi-Fi Repeaterconnection with parent AP.Off: Disconnected from parent AP.Quick Setup with WPS (Wi-Fi Protected Setup)For router/Access Point(AP) with WPS support3 Place in an ideal locationAfter placing your RP-AC53 in an ideal location, RP-AC53 connects to your router/AP in about one (1) minute.NOTES:• Place your RP-AC53 between yourrouter/AP and wireless device to getthe best extender performance.• Place your RP-AC53 in a locationwhere you can get green or orangeWi-Fi LED.IMPORTANT! We recommend that you place your RP-AC53 in open or spacious location.Enjoy!1 2Frequently Asked Questions (FAQ)Q1: What should I do if my router does not support WPS?A1: You can use Method Two to set up RP-AC53.Q2: How do I reset RP-AC53?A2: Press the RESET button on the side of RP-AC53 for about five (5) sec-onds until the LEDs blink slowly.Q2: What should I do when only one band Wi-Fi LED is on?A2: When you are connecting to a dual-band router but only 2.4 GHz or 5 GHz Wi-FiLED is on, press the WPS button on both the router and the RP-AC53 again andcheck that both 2.4 GHz and 5 GHz Wi-Fi LEDs are on.Q4: What should I do if RP-AC53 web interface is not accessible?A4: You can do any of the following:• Connect your computer and RP-AC53 using an Ethernet cable, andconnect to RP-AC53’s SSID or network name.• Set up your computer to obtain an IP address automatically.• On a web browser, ensure that you correctly enter the web addresshttp://repeater.asus.comMethod OneYour RP-AC53’s wireless network name (SSID) chang-es to your existing Wi-Fi network name, ending with_RPT or _RPT5G and shares your router/AP’s WirelessPassword.Power OnPlace your RP-AC53 near your router/AP and plug it to apower outlet.Press the power switch to ON. Waituntil the power LED turns solid greenand Wi-Fi LEDs stop blinking, indicatingthat RP-AC53 is ready to connect to theparent AP.Connect via WPS (Wi-Fi Protected Setup)1. Press the WPS button on yourRouter/AP.2. Press the WPS button on your RP-AC53 formore than five (5) seconds until the LEDsstart to blink.NOTE: Ensure that your router/AP supports WPS. Otherwise, use Method TWO.The LEDs flash about two(2) minutes and turn solidgreen. The color of theLED indicates the Wi-Fisignal strength.E11934_RP-AC53_QSG_Special_V2.indd 1 2016-08-19 16:20:19

/ 2

Related manuals for Asus RP-AC53