Asus R300 User Manual

Also see for R300: Quick start guide User manual Quick start guide User manual

Contents

1• Address: you can specify an address to be searched around, or a settlement to search in.The centre of this settlement will be used as the reference point.• History: the reference for the search can be selected from the History list.• Coordinates: you can specify a latitude/longitude pair to be the centre of the search.• Current GPS Position: the search will be carried out around the current location given by theGPS if it is available. If no GPS position is available, the last known GPS position (grey arrowon the map) will be used.• Cursor: the search will be carried out around the previously selected map point.• Destination: the search will be carried out around the destination of your current route.The current selection is always shown in the green field at the top of the page.Note: The default reference point for POI search is the current GPS position, if it is available,or the Cursor, when there is no reliable GPS position.Once you have set the reference point, you have the following options on the Find POIscreen:• Find in POI subgroups: highlight one of the POI groups by tapping or using the directionbuttons, then press Enter or tap it again to see the list of subgroups. Using the same actionyou can move deeper into subgroups.• Search by name among the POIs of that level: tapping the Search button will bring up a textinput screen to let you narrow the list of POIs. If you tap Search in the list of subgroups, youwill only search in the group you are already in.