Asus A2D Hardware User Manual

Also see for A2D: User manual User guide User guide

Contents

69Appendix ALaser ClassificationsAs lasers became more numerous and more widely used, the need to warn users of laser hazards be-came apparent. To meet this need, laser classifications were established. Current classification levelsvary from optically safe, requiring no controls (Class 1) to very hazardous, requiring strict controls(Class 4).CLASS 1: A Class 1 laser or laser system emits levels of optical energy that are eye-safe and conse-quently require no controls. An example of this class of laser system is the checkout scanning devicefound in most grocery stores or lasers used in optical drives.CLASS 2 AND CLASS 3A: Class 2 and Class 3A lasers emit visible, continuous-wave (CW) opticalradiation levels slightly above the maximum permissible exposure (MPE) level. Although these la-sers can cause eye damage, their brightness usually causes observers to look away or blink beforeeye damage occurs. These lasers have strict administrative controls requiring placement of signswarning personnel not to stare directly into the beam. Class 3A lasers must not be viewed withoptically-aided devices.CLASS 3B: Class 3B lasers, and Class 3A lasers with outputs of 2.5mW, are hazardous to personnelwho are within the beam path and look at the beam source directly or by specular reflection. Theselasers cannot produce hazardous diffuse reflections. Personnel working with these lasers should wearappropriate protective eyewear during any operation of the laser. Class 3B lasers have both adminis-trative and physical controls to protect personnel. Physical controls include limited access workareas. Administrative controls include special warning signs posted outside the entrances to the laserwork spaces and lights outside the entrances that warn personnel when the lasers are in use.CLASS 4: Class 4 lasers are high-power lasers that will cause damage to unprotected eyes and skinthrough intra-beam viewing and specular or diffuse reflections. Consequently, no personnel shouldbe in aroom where a Class 4 laser is operating without proper eye protection.LPT Port (Line Printer Port)Logical device name reserved by DOS for the computer parallel ports. Each LPT port is configured touse a different IRQ and address assignment.PCI Bus (Peripheral Component Interconnect Local Bus)PCI bus is a specification that defines a 32-bit data bus interface. PCI is a standard widely used byexpansion card manufacturers.PC Cards (PCMCIA)PC cards are about the size of a few stacked credit cards and have a 68-pin connector at one end. The PCCard standard accommodates a number of function, communication, and data storage expansion op-tions. PC cards come in memory/flash cards, fax/modems, networking adapters, SCSI adapters, MPEGI/II decoder cards, and even wireless modem or LAN cards. The Notebook PC supports PCMCIA 2.1,and 32-bit CardBus standards. The three different PC Card standards actually have different thick-nesses. Type I cards are 3.3mm, Type II cards are 5mm, and Type III cards are 10.5mm thick. Type I andType II cards can be used in a single socket. Type III cards take up two sockets and must be used onNotebook PCs with two sockets.