Gateway: This option shows the print server’s current gateway address maybe obtained from theDHCP server or manually specified. The option also allows you to manually specifythe IP address of the gateway to the print server, if DHCP option is disabled. Thisvalue is optionalUpgradeUpgrade allows the user to upgrade the print server device. In order to upgrade the unit pleaseperform the steps as follows:1. Click Upgrade button just like a picture < >, as shown as follow picture2. Select General Upgrade. Make sure that the upgrade file is located in the same directory asPSAdmin.Reset1. Click Reset button just like a picture < >.2. Reset allows the user to reset the print server device in order to establish a new connection orfor new settings to take effect.Refresh1. Click Reset button just like a picture < >.2. Refresh searches the network for all attached print server(s).Note: Configure the print speed in the Advanced label, must match the printer’s speed whichconnect to the print server. Undependable configuration will cause printer to abnormalprinting.