68 PCM 5820/5820L User's Manual7.1 IntroductionThe PCM-5820 is equipped with a high performance 32-bitEthernet chipset which is fully compliant with IEEE 802.3 100Mbps CSMA/CD standards. It is supported by major networkoperating systems. It is also both 100Base-T and 10Base-Tcompatible. The medium type can be configured via theRSET8139.exe program included on the utility disk.The Ethernet port provides a standard RJ-45 jack on board. Thenetwork boot feature can be utilized by incorporating the bootROM image files for the appropriate network operating system.The boot ROM BIOS files are combined with system BIOS, whichcan be enabled/disabled in the BIOS setup.7.2 Installation of Ethernet driverBefore installing the Ethernet driver, note the procedures below.You must know which operating system you are using in yourPCM-5820, and then refer to the corresponding installation flowchart. Then just follow the steps described in the flow chart. Youwill quickly and successfully complete the installation, even if youare not familiar with instructions for MS-DOS or WINDOWS.Note: The windows illustrations in this chapter areexamples only. You must follow the flow chartinstructions and pay attention to the instructionswhich then appear on your screen.7.2.1 Installation for MS-DOS & Windows 3.1If you want to set up your Ethernet connection under the MS-DOSor Windows 3.1 environment, you should first check your serversystem model. For example, MS-NT, IBM-LAN server, and so on.Then choose the correct driver to install in your panel PC.The installation procedures for various servers can be found onCD-ROM; the correct path being "D:\5820\Ethernet.100\wfw311".
