9-29enclosure Commandsenclosure show powerTo display the status of a specific power supply on a specific SAF-TE enclosure management device, use the enclosure showpower command. You can also use this command to display thestatus of all power supplies on the enclosure management deviceor devices.Syntaxenclosure show power [{enclosure}][{powersupply}]Parameters{enclosure}Specifies the ID associated with the enclosure managementdevice for which you want to display power supply statusinformation. For this version, the controller supports amaximum of eight enclosure management devices on eachbus.If you do not specify an ID, the command displays the powersupply status for all enclosure management devicesconnected to the controller.{powersupply}Specifies the unit number associated with the power supplywhose status you want to display. This integer can range from0 to 15 inclusive.If you do not specify a unit number, the command displaysthe status for all power supplies on the enclosuremanagement device or devices.ExamplesThe following example displays the status of the power supplies onenclosure management devices 0 and 1:AAC0>enclosure show powerExecuting: enclosure show powerEnclosure Power State Status--------- ----- ------------ -------0 0 OK ON1 0 OK OFF
