Appendix C: Using the Adaptec RAID Configuration Utility ● 113PHY SettingsFormatting and Verifying Disk DrivesYou can use the disk utilities to low-level format or verify your disk drives. (New disk drivesare low-level formatted at the factory and do not need to be low-level formatted again.)Caution: Before you format a disk drive, back up all data. Formatting destroys all data ona disk drive.To format or verify a disk drive:1 Start the ARC utility (see page 105).2 Select the controller you want, then press Enter.3 Select Disk Utilities.4 Select the disk drive you want, then press Enter.5 Select Format Disk or Verify Disk Media.Locating Disk DrivesNote: This feature is only available with disk drives that have an activity LED.You can use the Identify Drive feature to physically locate a disk drive by blinking the LED.To locate a disk drive:1 Start the ARC utility (see page 105).2 Select the controller you want, then press Enter.3 Select Disk Utilities.4 Select the disk drive you want, then press Enter.5 Select Identify Drive, then press Enter.6 When you have finished locating your disk drive, press any key to stop the blinking.Option DescriptionPHY Rate The data transfer rate between the controller and devices. The default setting isAuto, which allows the SAS card to adjust the data transfer rate, as needed. Forlow-port 5-series RAID controllers (5085, 5405), you can set the PHY rate to1.5Gb/second or 3.0Gb/second (the maximum rate).CRC Checking When enabled, determines whether the controller verifies the accuracy of datatransfer on the serial bus. Default setting is Yes (enabled). Set to No (disabled)only if the controller is connected to a device that does not support CRC Checking.SAS Address In a situation where you want each phy on a controller to be in a different SASdomain, this setting specifies a unique world-wide name for each phy. Defaultis 0.Note: This setting is for SAS address conflict resolution only and should otherwiseremain at its default value.!
