uuHomeLink® Universal TransceiveruTraining HomeLink196Features■ Training a Button 1Training HomeLinkRetraining a ButtonIf you want to retrain a programmed button for anew device, you do not have to erase all buttonmemory. You can replace the existing memory codeusing this procedure:1. Press and hold the desired HomeLink buttonuntil the HomeLink indicator begins to blink.2. Continue to hold the HomeLink button andfollow steps 1 - 3 under “Training a Button.”Indicator remains onfor about 25 secs.Standard transmitterIndicator blinks rapidly for2 secs, then remains on forabout 23 secs.Rolling code transmitterErasing CodesTo erase all the codes, press and hold the two outsidebuttons until the HomeLink indicator begins to blink(about 10 to 20 secs). You should erase all codesbefore selling the vehicle.If you have any problems, see the device’sinstructions, visit www.homelink.com, or callHomeLink at (800) 355-3515.4.a.3.2.5. a.b.1. Position the remote transmitter you wish to link 1 to 3 inches (3 - 8 cm) from theHomeLink button you want to program.Press and hold the desired HomeLink button and the button onthe remote transmitter.Does the HomeLink indicator (LED) blinkafter 10 secs?Press and hold theprogrammed HomeLinkbutton for about a sec.Does the device (garagedoor opener) work?Press and hold the remote and the HomeLinkbutton at the same time. Then, whilecontinuing to hold the HomeLink button,press and release the button on the remoteevery 2 secs.Does the LED blink within 20 secs?TrainingCompletePress and hold the HomeLink button again.Press and hold the HomeLinkbutton again.The remote-controlled deviceshould operate.Training CompleteThe remote has a rolling code. Press the“learn” button on the remote-controlleddevice (e.g. garage door opener).Within 30 secs, press and hold theprogrammed HomeLink button for 2 secs.HomeLink indicator blinks for 2 secs,then remains on.HomeLink LEDis on.YES NOYESYES NO NO
