Operation Manual, Xymba XB-42 V10810 © 2008, Acronova Technology, Inc.Important:The Finish Disc Bin must be in position during operation.Removing the Finish Disc Bin will stop Xymba from operatingimmediately after the current disc being written to has completed.Rear View Power SocketUse the provided powercord to connect Xymba toa wall outlet. Power SwitchTurn Xymba on and off. VentilationThis allows heat to escape.Do not block this otherwisethe unit may overheat.Control Panel High-Speed DuplicationPress to start the duplication process atthe highest possible write speed toproduce discs at the maximumproduction rate. Safe-Speed DuplicationPress to start normal speed duplication.This increases quality but decreasesoutput rate. Recommended for audioand video discs. Function KeyPress this button to activate ordeactivate disc verification during theduplication process. Test/AbortPress to abort the current duplication process or to start aduplication simulation.Important:The High-Speed Duplication mode will use the maximum recorderspeed but may be limited by the write speed of the disc