52English 7 Some parameters required for compliance with Telecom'sTelepermit requirements are dependent on the equipment (PC)associated with this device. The associated equipment shall be setto operate within the following limits for compliance withTelecom's specifications, the associated equipment shall be set toensure that calls are answered between 3 and 30 seconds ofreceipt of ringing.8 This equipment shall not be set up to make automatic calls toTelecom's 111 Emergency Service.Important safety instructionsRead these instructions carefully. Save them for future reference.1 Follow all warnings and instructions marked on the product.2 Unplug this product from the wall outlet before cleaning.Do not use liquid cleaners or aerosol cleaners. Use a damp clothfor cleaning.3 Do not use this product near water.4 Do not place this product on an unstable cart, stand, or table. Theproduct may fall, causing serious damage to the product.5 Slots and openings are provided for ventilation; to ensure reliableoperation of the product and to protect it from overheating.These openings must not be blocked or covered. The openingsshould never be blocked by placing the product on a bed, sofa,rug, or other similar surface. This product should never be placednear or over a radiator or heat register, or in a built-in installationunless proper ventilation is provided.6 This product should be operated from the type of power indicatedon the marking label. If you are not sure of the type of poweravailable, consult your dealer or local power company.7 Do not allow anything to rest on the power cord. Do not locatethis product where persons will walk on the cord.8 If an extension cord is used with this product, make sure that thetotal ampere rating of the equipment plugged into the extensioncord does not exceed the extension cord ampere rating. Also,make sure that the total rating of all products plugged into thewall outlet does not exceed the fuse rating.9 Never push objects of any kind into this product through cabinetslots as they may touch dangerous voltage points or short out