|
63EnglishRestore from backupYou can restore backups previously created (as stated in the Create backupsection) from hard drive, CD, or DVD.1 Boot to Windows XP.2 Press + to open the Acer eRecovery Management utility.3 Enter the password to proceed. The default password is six zeros.4 In the Acer eRecovery Management window, select Recovery actions andclick Next.5 Select the desired restore action and follow the onscreen instructions tocomplete the restore process.Note: The "Restore C:" item is enabled only if there is a userbackup stored on the hard drive (D:\). Please refer to the Createbackup section.Create factory default image CDWhen the System CD and Recovery CD are not available, you can create them byusing this feature.1 Boot to Windows XP.2 Press + to open the Acer eRecovery Management utility.3 Enter the password to proceed. The default password is six zeros.4 In the Acer eRecovery Management window, select Recovery settings andclick Next.5 In the Recovery settings window, select Burn image to disk and click Next.6 In the Burn image to disk window, select 01. Factory default image andclick Next.7 Follow the instructions on screen to complete the process.Re-install bundled software without CDAcer eRecovery Management stores pre-loaded software internally for easydriver and application re-installation.1 Boot to Windows XP.2 Press + to open the Acer eRecovery Management utility.3 Enter the password to proceed. The default password is six zeros.4 In the Acer eRecovery Management window, select Recovery actions andclick Next.
|
