2-10 System UtilitiesRemoving a Password 0Perform the following:1. Use the ↑ and ↓ keys to highlight Set Supervisor Password and pressEnter. TheSet Supervisor Password dialog box appears:Figure 2-5. Set Supervisor Password2. Type current password in Enter Current Password field and pressEnter.3. PressEnter twice without typing anything in Enter New Password and ConfirmNew Password fields. Computer will set Supervisor Password parameter toClear.4. PressF10 to save changes and exit theBIOS Setup Utility.Changing a Password 01. Use the ↑ and ↓ keys to highlight Set Supervisor Password and pressEnter. TheSet Supervisor Password dialog box appears.Figure 2-6. Set Supervisor Password2. Type current password in Enter Current Password field and pressEnter.3. Type new password in Enter New Password field. Retype new password inConfirm New Password field.4. PressEnter. Computer sets Supervisor Password parameter to Set.NOTE:NOTE:Password on Boot must be set to Enabled to activate the password feature.5. PressF10 to save changes and exitBIOS Setup Utility.If the verification is OK, the screen will show as follows.Figure 2-7. Setup Notice
