Troubleshooting 4-13Microphone Failure 0If internal or external Microphones fail, perform the following, one at a time.Figure 4-7. Microphone Failure1. Check that the microphone is enabled. Navigate to Start Control Panel Hardwareand Sound Sound and select the Recording tab.2. Right click on the Recording tab and select Show Disabled Devices (clear bydefault). The microphone appears on the Recording tab.3. Right click on the microphone and select Enable.4. Select the microphone then click Properties. Select the Levels tab.5. Increase the volume to the maximum setting and click OK.6. Test the microphone hardware:Select the microphone and click Configure.Select Set up microphone.Select the microphone type from the list and click Next.Follow the on-screen prompts to complete the test.7. If the issue is still not resolved, refer to the Online Support Information on page 9-3.StartIs MIC cablewell connected?Is MICOK?Replace M/BReconnect theMIC cableOKNGReplace the MICOKNG