Acer Aspire 5517 Service Manual

Also see for Aspire Z5751: User guide Service guide

Contents

Acer Aspire 5517 Service Manual Manual pdf 137 page image

Chapter 4 127Sound ProblemsIf sound problems are experienced, perform the following actions one at a time to correct the problem.1. Reboot the computer.2. Navigate to Start´ Control Panel´ System and Maintenance´ System´ Device Manager. Checkthe Device Manager to determine that:• The device is properly installed.• There are no red Xs or yellow exclamation marks.• There are no device conflicts.• No hardware is listed under Other Devices.3. Roll back the audio driver to the previous version, if updated recently.4. Remove and reinstall the audio driver.5. Ensure that all volume controls are set mid range:a. Click the volume icon on the taskbar and drag the slider to 50. Ensure that the volume is not muted.b. Click Mixer to verify that other audio applications are set to 50 and not muted.6. Navigate to Start´ Control Panel´ Hardware and Sound´ Sound. Ensure that Speakers are selectedas the default audio device (green check mark).NOTE: If Speakers does not show, right-click on the Playback tab and select Show Disabled Devices(clear by default).7. Select Speakers and click Configure to start Speaker Setup. Follow the onscreen prompts to configurethe speakers.8. Remove and recently installed hardware or software.9. Restore system and file settings from a known good date using System Restore.If the issue is not fixed, repeat the preceding steps and select an earlier time and date.10. Reinstall the Operating System.11. If the Issue is still not resolved, see “Online Support Information” on page 167.Microphone ProblemsIf internal or external Microphones do no operate correctly, perform the following actions one at a time tocorrect the problem.1. Check that the microphone is enabled. Navigate to Start´ Control Panel´ Hardware and Sound´Sound and select the Recording tab.2. Right-click on the Recording tab and select Show Disabled Devices (clear by default).3. The microphone appears on the Recording tab.4. Right-click on the microphone and select Enable.5. Select the microphone then click Properties. Select the Levels tab.6. Increase the volume to the maximum setting and click OK.7. Test the microphone hardware:a. Select the microphone and click Configure.b. Select Set up microphone.c. Select the microphone type from the list and click Next.d. Follow the onscreen prompts to complete the test.8. If the Issue is still not resolved, see “Online Support Information” on page 167.