Accusplit AE2740 Instructions Manual

Also see for AE2740: Instructions Instructions

Accusplit AE2740 Instructions Manual Manual pdf 1 page image

SETTING UP YOUR PEDOMETERTo record your distance accurately, you will need toset your stride length.Finding Your Stride Length: Your stride length is thelength of one of your steps, measured from “toe totoe.” To measure, walk 10 steps with your normalstride and measure the TOTAL DISTANCE from thetoe of your starting step to the toe of your 10th step(see diagram below). Divide the TOTAL DISTANCEby 10, and multiply the decimal portion by 12 to findyour stride length in feet and inches. Example: If youwalk 23 feet in 10 steps, your stride length is 2.3 feet.Multiply 0.3 x 12 = 4. Your stride length is 2 feet, 4inches.Setting Your Stride Length: Repeatedly press the redMODE button until indicator points to “DIST.” Pressthe blue SET button once to enter setting mode.Display will shift to show stride, in feet and inches.Press and hold down the blue SET button to increasestride length. Press the red MODE button to exitsetting mode.Note: Pressing the white RESET button resetsstride length to 2' 0".AE2740 PedometerINSTRUCTIONSACCUSPLIT, Inc. • 3090 Independence Drive, Suite 148 • Livermore, CA 94551 USA800-935-1996 • 925-290-1900 • FAX 925-290-1930 • www.ACCUSPLIT.com • support@ACCUSPLIT.comAttaching the Leash: Attach the pedometer to theleash by looping the leash through the pedometerleash slot. Next, loop the leash through the metalclip, then clasp the waistband of your clothingwith the pedometer belt clip. You can also use asafety pin to fasten the leash to your clothing, loopthe leash through your belt or belt loop, or use abadge holder.VIEWING YOUR RESULTSOnce you put on your pedometer with the coverclosed, it will automatically begin to record yoursteps, distance, and activity time. Repeatedlypress the red MODE button to cycle through thepedometer modes:STEP → DISTANCE → ACTIVITY TIMER → STEPRESETTING YOUR PEDOMETERMost people prefer to reset step and distance daily.To reset: From STEP, DISTANCE, or ACTIVITY TIMERmode, press and hold the white RESET button for atleast 2 seconds.CHANGING UNITS (English vs. Metric)The Pedometer can display either in English units(inches, miles, and pounds - this is the default), or inMetric units (cm, km, and kg). To change betweendisplay modes, push and hold the red MODE buttonfor 5 seconds, until you see all display indicatorsmomentarily come on. You can check to see whichsystem of units you are using by repeatedly pressingthe red MODE button until it displays either MI or KMwhen showing Distance traveled.REPLACING THE BATTERYWhen the display starts to dim or goes blank, it istime to replace the battery. Your pedometer uses oneType L1142 (LR43) 1.5 volt silver oxide battery.To replace:1. Insert a coin into the slot on the front of thecase, and twist counterclockwise to loosenthe battery door.2. Remove battery door and take out the oldbattery. Replace it with a new battery. Thebattery’s positive (+) terminal should beFACE UP while you put it into the pedometer.3. Put the battery door back on and twist thecoin clockwise to tighten.Congratulations on taking the first step to wellnesswith your purchase of an ACCUSPLIT pedometer.It’s easy to set up your new pedometer.Just follow the steps below, and start walking!10 steps970-077First, loop thepedometer leash slotNext, loop the metalclip, then clasp clothingOr, loop abadge holder,then put into pocket(Badge holdernot included)Or, loop a belt or belt loopRed:MODE9789 STEPDIST▶Blue:SETWhite:RESETDISPLAY MODES• STEP: STEP mode shows your step countsince last reset, up to 1,000,000 steps.• DIST: DISTANCE mode shows distancewalked or jogged since last reset.• ◯: ACTIVITY TIMER MODE showstotal activity time in minutes andseconds since last reset. The timerruns automatically whenever stepsare being recorded.HOW TO OPEN YOUR PEDOMETERSee diagrams at right.The cover must be closedfor the pedometer to work.ACCUSPLITALLIANCE 1520ACCU STEP10000.ORG RESETACTIVITYPEDOMETERSTEP0 68440WEARING YOUR PEDOMETERGently slide the pedometer onto your belt or thetop edge of your pants or skirt. It should fit snuglyand level, above one knee. The strong steel clipmakes it easy.Note: The pedometer should be as vertical aspossible. Walkers with larger stomachs may find ithelpful to wear the pedometer farther back on thebody, toward one hip.The cover must be closed for the pedometer towork.To avoid losing or dropping your pedometer, usethe included leash and clip to fasten the pedom-eter securely to your clothing.yesno3-STEP DELAY FILTERACCUSPLIT has added a “3 step delay” filter to this pedometer, to weed out false steps causedby tapping the foot, sitting down, etc. The filter is set to “3 steps,” meaning that the unit will waitto start counting steps until more than three steps have been recorded. When you are beginninga walk, the display will not show any steps for a few seconds. After the unit has sensed foursteps, the display will register all of those steps at once, and keep counting from that point.

/ 1

Related manuals for Accusplit AE2740