System Management Commands4-494logging sendmail hostThis command specifies SMTP servers that will be sent alert messages. Use the noform to remove an SMTP server.Syntax[no] logging sendmail host ip_addressip_address - IP address of an SMTP server that will be sent alertmessages for event handling.Default SettingNoneCommand ModeGlobal ConfigurationCommand Usage• You can specify up to three SMTP servers for event handing. However, youmust enter a separate command to specify each server.• To send email alerts, the switch first opens a connection, sends all the emailalerts waiting in the queue one by one, and finally closes the connection.• To open a connection, the switch first selects the server that successfully sentmail during the last connection, or the first server configured by this command.If it fails to send mail, the switch selects the next server in the list and tries tosend mail again. If it still fails, the system will repeat the process at a periodicinterval. (A trap will be triggered if the switch cannot successfully open aconnection.)Examplelogging sendmail levelThis command sets the severity threshold used to trigger alert messages.Syntaxlogging sendmail level levellevel - One of the system message levels (page 4-44). Messages sentinclude the selected level down to level 0. (Range: 0-7; Default: 7)Default SettingLevel 7Command ModeGlobal ConfigurationConsole(config)#logging sendmail host 192.168.1.19Console(config)#
