Command Line Interface4-284ExampleRelated Commandsenable (4-20)IP Filter CommandsmanagementThis command specifies the client IP addresses that are allowed managementaccess to the switch through various protocols. Use the no form to restore thedefault setting.Syntax[no] management {all-client | http-client | snmp-client | telnet-client}start-address [end-address]• all-client - Adds IP address(es) to the SNMP, Web and Telnet groups.• http-client - Adds IP address(es) to the Web group.• snmp-client - Adds IP address(es) to the SNMP group.• telnet-client - Adds IP address(es) to the Telnet group.• start-address - A single IP address, or the starting address of a range.• end-address - The end address of a range.Default SettingAll addressesCommand ModeGlobal ConfigurationCommand Usage• If anyone tries to access a management interface on the switch from an invalidaddress, the switch will reject the connection, enter an event message in thesystem log, and send a trap message to the trap manager.• IP address can be configured for SNMP, Web and Telnet access respectively.Each of these groups can include up to five different sets of addresses, eitherindividual addresses or address ranges.Console(config)#enable password level 15 0 adminConsole(config)#Table 4-11. IP Filter CommandsCommand Function Mode Pagemanagement Configures IP addresses that are allowed management access GC 4-28show management Displays the switch to be monitored or configured from abrowser PE 4-29
