Chapter 3 Entering softpatch and system settings 17Entering default one-to-one softpatchThe one-to-one softpatch assigns dimmer 1 to channel 1, dimmer 2 tochannel 2, and so on. If you have more dimmers than channels, thedefault setting assigns the first extra dimmer to channel 1, the secondextra dimmer to channel 2, and so on.Follow these steps to create a one-to-one softpatch:1. Press [Setup]. Display reads:Setup UtilityDISK PRINT CONFIG2. Press [F3] (Config); display reads:Select Setup DesiredPATCH CONSOLE QUIT3. Press [F1] (Patch). One of six patch option screens appears in theLCD Operator Display. Use [F1] (Last) and [F2] (Next) to scrollthrough the patch options until screen reads as below.6 Set Default Patch NOLAST NEXT CHANGE4. Press [F3] (Change) until display reads:6 Set Default Patch YESCONFIRM QUIT5. Press [F1] (Confirm) to confirm your choice, or press [F3] (Quit) toreturn to previous screen.6. Press [Setup] to enter the default softpatch and return to regularoperation.Note: All dimmers are automatically set at the default output level inthe default softpatch. The factory-set default is 100 percent. Forinformation on changing the default level see page XX.www.carlosmendoza.com.mx
