Operational Features5-234 41-001160-03 Rev 00, Release 2.5IP Phone Administrator GuidePark/Pick Up Key (not applicable to the 6751i)The IP phones (including the CT handsets) have a park and pickup call featurethat allows you to park a call and pickup a call when required. There are two waysa user or administrator can configure this feature:• Using a static configuration (globally configures park and pickup)• Using a programmable configuration (using a key)The IP phones support the Park/Pickup feature on the Asterisk, BroadWorks,Sylantro, and ININ PBX servers.The following paragraph describes the configuration of a park and pickup key onthe IP phone. For information about configuring the park and pickup staticconfiguration method see “Park Calls/Pick Up Parked Calls” on page 5-59.Park/Pickup Programmable Configuration (using a key)The programmable method of configuration creates park and pickup keys(softkeys, programmable keys, expansion module keys) that you can configure onthe IP phones.For all phones (EXCEPT the 6751i) you can set a key as "Park" or "Pickup" andthen:• specify a customized label to display on the Phone UI• specify a value• specify which line to use• specify the state of the park and/or pickup keysFor 3-Line LCD display phones (not applicable to 6751i) , you can set aprogrammable key as "Park" or "Pickup" and then:• specify a value• specify a line to useNote: The IP phones accept both methods of configuration. However, toavoid redundancy, Aastra Telecom recommends you configure either astatic configuration or a programmable configuration.
