Supplementary featureseud-1292/1.1 – R1.0 – 09.2011 63Setting functions by remote controlThis section explains how you can alter your phone’s settings even if you are notdirectly at your phone.You are not at your desk and want to set various functions on your phone from a dif-ferent phone.You can activate/deactivate many of your phone's functions by remote control from adifferent phone.The remote control is initiated using a special */# procedure. You can then enter thefunction commands and */# procedures. Using remote control from a third-party phone:1. Enter procedure #36.2. Enter your phone number.3. Enter your PIN.4. Enter the */# procedure for activating/deactivating the function you want.Press the Call key.➔Acknowledgement tone sounds; function is activated/deactivated.Note:The default PIN setting "0000" is not accepted. First change the PIN asdescribed in chapter "Changing the User PIN", page 78 or use */#procedure *47 (see "User’s Guide */# Procedures" on the Aastra documentportal: www.aastra.com/docfinder). If you have forgotten your PIN, your systemadministrator can reset it to the default setting.
