A&D EJ-120 Instruction Manual

A&D EJ-120 Instruction Manual Manual pdf 27 page image

25 Key modeSet the function “prt 1, 2 or 3”.When the PRINT key is pressed while the weighing data is stable (the STABLEindicator is on), the balance transmits the data. When the data is transmitted, thedisplay will blink one time. Auto-print mode ASet the function “prt 2”.The balance transmits the weighing data when the display is stable (the STABLEindicator is on) and the data is greater than +4d.The next output can be obtained after the display returns below +4d. Auto-print mode BSet the function “prt 3”.The balance transmits the weighing data when the display is stable (the STABLEindicator is on) and the data is greater than +4d or less than -4d.The next output can be obtained after the display returns between -4d and +4d.Command modeIn the command mode, the balance is controlled by commands that come from thepersonal computer and so on.Command list Command to request the current weighing data.Command Q CR LFReply S T , + 0 0 1 2 3 4 . 5 g CR LF Command to zero or tare the balance (same as the RE-ZERO key).Command Z CR LFReply Z CR LF Command to change the weighing units (same as the MODE key).Command U C R LFReply U CR LF