A&D BM series Instruction Manual

Also see for BM series: Instruction manual

Contents

A&D BM series Instruction Manual Manual pdf 73 page image

BM series 7113. UnderhookThe underhook can be used for magnetic materials or density measurement. The built-inunderhook is revealed by removing the cap on the bottom of the balance. Use the underhook asshown below.CautionDo not apply excessive force to the underhook.When not in use, attach the cap to prevent dust fromgetting into the balance.Do not push the underhook upwardWhen turning the balance over, parts and weighingsample in the weighing chamber will fall off. (Parts: theweighing pan, pan support, breeze break ring, fine rangering and dust plate )Remove them first.When the cap is removed, a weighing error may occur,because of drafts entering into the internal portion of thebalance. Arrange the room condition.1 Remove the cap on the bottom of the balance.2 Hang your weighing pan on the underhook.Place the balance on the solid table.BottomUnderhookCapSolid tableequipped with a hole.Weighing pan