AGA EC3 Users Instructions & Cooking Manual

Also see for AIMS EC3: Owner's manual Installation instructions Users instructions & cooking guide Users instructions & cooking guide Owner's manual

Contents

AGA EC3 Users Instructions & Cooking Manual Manual pdf 11 page image

This screen shows that the ovens will be up at ‘Normal’ temperature between 07:00 and 10:00the ovens will then go to the ‘Low’ mode.The ovens will come up to ‘Normal’ once more in that day i.e. at 16:00 until 19:00. After theevening the system will automatically enter ‘Slumber’ mode its lowest setting until next morning.AIMS PROGRAMME SCREEN2214Fig. 7 DESN 51527434311Use the button to activate this screen and to move through the different actionsand set an AIMS programme. To go back a step at any time press .1. Set the frequency of the programme Once or Twice daily using + and - buttons.2. Press button to select start time for ‘Normal’ setting then use the + or - buttons toset start time.3. Press the button to select finish time then use + and - buttons to set finish time.When a time is selected it will be highlighted in dark blue.4. Press the button then press the button to alter the temperature setting to ‘Low’,‘Slumber’, or ‘Off’. (Repeat steps 2 - 4 to set a 2nd event)To copy this days settings for the next day press the button or alternatively pressthe button to enter different settings for next day.Each push of the copy button steps onto next day. When the desired days have beenprogrammed a return must be made to the main menu screen by pressing the button.A ‘Sent OK’ message will display to confirm changes are being sent to the base unit.If the programme is not set for the whole week the programme for the remaining days willrevert to a default setting. ie: 8:00 am - 9:00 am and 18:00 - 19:00.To change a setting within the AIMS program, press the button until the desired settingis reached. Then change setting using either the +, - or buttons as appropriate.If no other changes are to be made,push the button to transmit the change (s) andreturn to main menu. A message saying ‘Sent OK’ will display, indicating that the changesare being transmitted to the base unit. Unless this shows, the changes will not have beenimplemented.