AEG SKD71800F0 User Manual

Also see for SKD71800F0: User manual User manual

AEG SKD71800F0 User Manual Manual pdf 6 page image

• Adequate air circulation should be around the appliance, lacking this leads to overheat-ing. To achieve sufficient ventilation follow the instructions relevant to installation.• Wherever possible the back of the product should be against a wall to avoid touchingor catching warm parts (compressor, condenser) to prevent possible burn.• The appliance must not be located close to radiators or cookers.• Make sure that the mains plug is accessible after the installation of the appliance.• Connect to potable water supply only. 3)Service• Any electrical work required to do the servicing of the appliance should be carried outby a qualified electrician or competent person.• This product must be serviced by an authorized Service Centre, and only genuine spareparts must be used.Environment ProtectionThis appliance does not contain gasses which could damage the ozone layer, in either itsrefrigerant circuit or insulation materials. The appliance shall not be discarded togetherwith the urban refuse and rubbish. The insulation foam contains flammable gases: theappliance shall be disposed according to the applicable regulations to obtain from yourlocal authorities. Avoid damaging the cooling unit, especially at the rear near the heatexchanger. The materials used on this appliance marked by the symbol are recyclable.CONTROL PANEL1 2 3 4 5 61 ON/OFF button2 Mode button3 OK button4 Temperature colder button5 Temperature warmer button6 DisplayIt is possible to change predefined sound of buttons to a loudly one by pressing togetherMode button and Temperature colder button for some seconds. Change is reversible.3) If a water connection is foreseen.6 Control panel