6.1 What to do if...Problem Possible cause SolutionThe appliance is noisy. The appliance is not sup-ported properly.Check if the appliance standsstable.A square symbol is showninstead of numbers on theTemperature Display.Temperature sensor prob-lem.Contact the nearest Author-ised Service Centre (the cool-ing system will continue tokeep food products cold, buttemperature adjustment willnot be possible).The lamp does not work. The lamp is in stand-by. Close and open the door.The lamp does not work. The lamp is defective. Contact the nearest Author-ised Service Centre.The compressor operatescontinually.Temperature is set incor-rectly.Refer to "Operation" chapter.Many food products wereput in at the same time.Wait some hours and thencheck the temperature again.The room temperature istoo high.Refer to climate class chart onthe rating plate.Food products placed inthe appliance were toowarm.Allow food products to cool toroom temperature before stor-ing.The FROSTMATIC functionis switched on.Refer to "FROSTMATIC func-tion".The compressor does notstart immediately afterpressing the FROSTMATIC,or after changing the tem-perature.This is normal, no error hasoccurred.The compressor starts after aperiod of time.Water flows inside the re-frigerator.The water outlet is clog-ged.Clean the water outlet.Food products prevent thatwater flows into the watercollector.Make sure that food productsdo not touch the rear plate.Water flows on the floor. The melting water outlet isnot connected to the evap-orative tray above the com-pressor.Attach the melting water out-let to the evaporative tray.ENGLISH 19