AEG S53430CNW2 User Manual

AEG S53430CNW2 User Manual Manual pdf 31 page image

8.2 Closing the door1. Clean the door gaskets.2. If necessary, adjust the door. Refer to"Installation".3. If necessary, replace the defectivedoor gaskets. Contact the ServiceCenter.8.3 Replacing the lampThe appliance is equipped with a longlifeLED interior light.Only service is allowed to replace thelighting device. Contact your ServiceCenter .9. INSTALLATIONWARNING!Refer to Safety chapters.9.1 PositioningThis appliance can be installed in a dry,well ventilated indoor where the ambienttemperature corresponds to the climateclass indicated on the rating plate of theappliance:ClimateclassAmbient temperatureSN +10°C to + 32°CN +16°C to + 32°CST +16°C to + 38°CT +16°C to + 43°CSome functional problemsmight occur for some types ofmodels when operatingoutside of that range. Thecorrect operation can only beguaranteed within thespecified temperature range.If you have any doubtsregarding where to install theappliance, please turn to thevendor, to our customerservice or to the nearestService Centre9.2 LocationThe appliance should be installed wellaway from sources of heat such asradiators, boilers, direct sunlight etc.Ensure that air can circulate freely aroundthe back of the cabinet. To ensure bestperformance, if the appliance ispositioned below an overhanging wallunit, the minimum distance between thetop of the cabinet and the wall unit mustbe at least 100 mm . Ideally, however, theappliance should not be positionedbelow overhanging wall units. Accuratelevelling is ensured by one or moreadjustable feet at the base of thecabinet.A B100 mmmin20 mm9.3 Electrical connection• Before plugging in, ensure that thevoltage and frequency shown on therating plate correspond to yourdomestic power supply.• The appliance must be earthed. Thepower supply cable plug is providedwith a contact for this purpose. If thedomestic power supply socket is notearthed, connect the appliance to aseparate earth in compliance withcurrent regulations, consulting aqualified electrician.• The manufacturer declines allresponsibility if the above safetyprecautions are not observed.• This appliance complies with theE.E.C. Directives.ENGLISH 31