AEG MCD1753E User Manual

AEG MCD1753E User Manual Manual pdf 34 page image

34 InstallationSafe use of the applianceIf fitting the microwave in position B or C (see diagram on page 33):• The cupboard must be a minimum of 500 mm (E) above the worktop and must notbe installed directly above a hob.• This appliance has been tested and approved for use near domestic gas, electricand induction hobs only.• Sufficient space between hob and microwave should be allowed to preventoverheating of microwave oven, surrounding cupboard and accessories.• Do not operate the hob without pans when the microwave oven is operating.• Care should be taken when attending to the microwave oven while the hob is on.Important: Ensure the bottom of the oven is 85 cm or more above the floor.It is important to ensure that the installation of this product conforms to theinstructions in this operation manual and the conventional oven manufacturer’sinstallation instructions.Connecting the appliance to the power supply• The electrical outlet should be readily accessible so that theunit can be unplugged easily in an emergency. Or it should bepossible to isolate the oven from the supply by incorporating aswitch in the fixed wiring in accordance with the wiring rules.• The socket should not be positioned behind the cupboard.• The best position is above the cupboard, see (A).• Connect the appliance to a single phase 230-240 V/50 Hzalternating current via a correctly installed earth socket.• If the appliance is to be operated in a non-Europeancountry, the supply voltage, current type and frequency ofthe appliance indicated on the rating plate must correspondwith the specification of your power supply. The rating platecan be found on the inside face of the control panel.• The power supply cord may only be replaced by an electrician.• Before installing, tie a piece of string to the power supplycord to facilitate connection to point (A) when the applianceis being installed.• When inserting the appliance into the high-sided cupboard,DO NOT crush the power supply cord.• Do not immerse the power supply cord or plug in water orany other liquid.(A)