3) During the Auto washing programme the amount of soil on the dishes is determined by how cloudy the wateris. The programme duration, water and energy consumption levels can vary; this depends upon if the applianceis fully or partially loaded and if the dishes are lightly or heavily soiled. The temperature of the water isautomatically adjusted between 45° C and 70° C.4) Ideal for washing a partially loaded dishwasher. This is the perfect daily programme, made to meet the needsof a family of 4 persons who only wish to load breakfast and dinner crockery and cutlery.5) This programme is foreseen with Care Plus function, which gives a greater degree of hygiene to dishes andglasses. In the last rinse phase the temperature will be held at over 65°C for at least 10 minutes.6) Test programme for test institutes.7) This programme does not require the use of detergentNIGHT CYCLE programmeNight Cycle is a silent washing programme that will not disturb you, even when you sleep.It can be set at night or in times with a more economical power rate.During the Night Cycle the pump runs at a very low speed to reach a noise level reductionof 25% compared to the declaration programme. As a consequence, it has a very longrunning time.Select and start a washing programme1. Check that the baskets have been loaded correctly and that the spray arms are free torotate.2. Check that the water tap is opened.3. Press the ON/OFF button.4. Select the washing programme. ( See "Washing programmes chart" ).5. If required, postpone the start time of the washing programme.6. Set, if required, the options.7. Press the OK / START button and close the door, the washing programme will startautomatically.If the delay start has been set, the countdown will start automatically. Once the delaystart has elapsed the programme will start automatically.The opening of the door will interrupt the countdown. Close the door; the countdownwill continue from the point at which it was interrupted.WARNING!Interrupt or cancel a washing programme in progress ONLY if it's absolutely nec-essary.Attention! Hot steam may escape when the door is opened. Open the door carefully.Cancel a delay start or a washing programme in progress1. Press RESET button.2. The message CONFIRM CANCEL ? is displayed.3. Press OK / START button to confirm.4. The appliance returns to setting mode and the message CHOOSE PROGRAMME isdisplayed.• If a delay start is cancelled, also set the washing programme has been cancelled.• If a new washing programme is set, check that there is detergent in the detergent dis-penser.22 Select and start a washing programme