AEG Electrolux 12830 Instruction Booklet

Contents

AEG Electrolux 12830 Instruction Booklet Manual pdf 55 page image

If you fit your own plug, the colours of the wires in the mains lead ofyour appliance may not correspond with the markings identifying theterminals in your plug, proceed as follows:Connect the green and yellow (earth) wire to the terminal in the plugwhich is marked with the letter «E» or the earth symbol or colouredgreen and yellow.Connect the blue (neutral) wire to the terminal in the plug which ismarked with the letter «N» or coloured black.Connect the brown (live) wire to the terminal in the plug which ismarked with the letter «L» or coloured red.The plug moulded on to the lead incorporates a fuse. For replacement, usea 13 Amp BS1363/A fuse. Only ASTA or BSI approved fuses should beused.The plug must not be used if the fuse cover/carrier is lost. Thecover/carrier is indicated by the coloured insert at the base of the plug.A replacement cover/carrier must be obtained from your local AEG ServiceCentre.The power supply cable must be easily accessible after installing themachine.Permanent connectionIn the case of a permanent connection it is necessary that you install adouble pole switch between the appliance and the electricity supply(mains), with a minimum gap of 3 mm between the switch contacts andof a type suitable for the required load in compliance with the currentelectrical regulations.The switch must not break the yellow and green earth cable at anypoint.This operation should only be performed by a qualified electrician.55Installation

/ 56

Related manuals for AEG Electrolux 12830