Door and glass panelsTo clean the door, remove it.CAUTION!Be careful when you remove the door from the appliance. The door is heavy!Removing the door1. Open the door as far as it goes.2. Fully press clamping levers (A) on thetwo door hinges.3. Close the door until the first position(angle approximately 70°).4. Hold of the door with one hand on eachside and pull it away from the at an upangle.To install the door follow the procedure inreverse.The number of glass panels if different for the different models.CAUTION!Put the door with the outer side down on a soft and level surface to prevent scratches.Removing and cleaning the door glass panels1. Remove the door.2. Hold the door trim (B) on the top edgeof the door at the two sides and pushinwards to release the clip seal.3. Pull the door trim to the front to re-move it.4. Hold the door glass panels on their topedge one by one and pull them up outof the guide5. Clean the door glass panels.To install panels follow the procedure in re-verse. Install the smaller panel first, then thelarger.AABCare and cleaning 29