SYM-BOLFUNCTION DESCRIPTIONEND To set when the appliance must be deactivated.First set an oven function before you set this func-tion. You can use Duration and End at the sametime (Time Delay) to set the time when the appli-ance must be activated and then deactivated.Press again and again tochange the clock function.Press to confirm the settingsof the clock functions, or wait 5seconds for the setting to beconfirmed automatically.6.1 Setting the DURATION orEND1. Press again and again until thedisplay shows or .or flashes in the display.2. Press or to the set minutes.3. Press to confirm.4. Press or to set the hour.5. Press to confirm. An acoustic sig-nal sounds for 2 minutes after thetime ends. or symbol andtime setting flash in the display. Theoven stops.6. Press any button or open the ovendoor to stop the acoustic signal.If you press when you set thehours for DURATION , theappliance goes to setting of theEND function.6.2 Setting the MINUTEMINDER1. Press .and "00" flash in the display.2. Press or to set the MINUTEMINDER. At first, the time is calcula-ted in minutes and seconds. Whenthe time you set is longer than 60minutes, the symbol comes on inthe display. The appliance now cal-culates the time in hours and mi-nutes.3. The MINUTE MINDER starts auto-matically after five seconds.After 90% of the set time, anacoustic signal sounds. Press abutton to stop the signal.4. When the set time ends, an acousticsignal sounds for two minutes."00:00" and flash in the display.Press a button to stop the signal.If you set the MINUTE MINDERwhen the DURATION or ENDfunction operates, the symbolcomes on in the display.6.3 Count Up TimerUse the Count Up Timer to monitor howlong the oven operates. It is on immedi-ately when the oven starts to heat.To reset the Count Up Timer, press andhold and .You cannot use the Count UpTimer when Duration or Endfunction operates.7. USING THE ACCESSORIESWARNING!Refer to the Safety chapters.ENGLISH 11