AEG BE3003001 User Manual

Also see for BE3003001: User manual User manual User manual User manual User manual

AEG BE3003001 User Manual Manual pdf 25 page image

CAUTION!Put a cloth on the bottom of theinterior of the appliance. It pre-vents damage to the lamp glasscover and the cavity.Always use the same lamp type.Replacing the lamp at the cavityceiling:1. Turn the lamp glass cover counter-clockwise to remove it.2. Clean the glass cover.3. Replace the lamp with a suitable 300°C heat-resistant lamp.4. Install the glass cover.10.3 Oven ceilingYou can fold down the heating elementon the oven ceiling to clean the ovenceiling easily.WARNING!Deactivate the appliance beforeyou fold down the heating ele-ment. Make sure that the appli-ance is cold. There is a risk ofburns.Folding down the heating element1. Remove the shelf supports.2. Hold the heating element with twohands at the front.3. Pull it forwards against the springpressure and out along the supportson the two sides.4. The heating element folds down.You can clean the oven ceiling.Installing the heating element1. Install the heating element in theopposite sequence.Install the heating element cor-rectly above the supports on theinner walls of the appliance.2. Install the shelf supports.10.4 Cleaning the oven doorRemoving the door and the glass panelsYou can remove the oven door and theinternal glass panels to clean it. Thenumber of glass panels is different fordifferent models.WARNING!Be careful when you remove thedoor from the appliance. Thedoor is heavy.AA1. Open the door fully.2. Fully press the clamping levers (A)on the two door hinges.3. Close the oven door to the firstopening position (approximately 70°angle).4. Hold the door with one hand oneach side and pull it away from theappliance at an up angle.ENGLISH 25