R3765/67G Series Network Analyzer Operation Manual7.4 RESPONSE Block7-167.4.4 Four Screen Display and Display Selection InformationThe 2 channels simultaneous display can be performed.Each channel has a sub-measure screen display, so that four-screen-display in total can be per-formed.Also the selection of the trace data, the coordinate display ON/OFF and the label input can beperformed.The Setting and the ExplanationPress the [DISPLAY] to call the display menu. (Refer to section A.4.)Display menu• Display menu (1 of 2){DUAL CH ON/OFF} : Selects ON/OFF of the two channels simultaneousdisplay (overlap display). (Note){SPLIT CH ON/OFF} : Selects ON/OFF of the display split in two, the upperpart and the lower part (split display). (Note){DISPLAY [ ]} : Calls the trace data selection menu to select whethermeasurement data, memory data and both data isdisplayed. (Refer to sub-section 7.4.6.){DEFINE TRACE [ ]} : Calls the trace operation menu.Four fundamental operations are executed for themeasured data and the memory data. (Refer to sub-section 7.4.7.){DATA → MEMORY} : Enters data into memory.When two-trace display has been selected, datatoggled by {TRACE 2nd/1st} is entered.{CONVERSION [ ]} : Calls the parameter selection menu to convert themeasured data into an impedance or an admittance.(Refer to of sub-section 7.4.1.){TRACE 2nd/1st} : Selects between the 1st trace and the 2nd trace.Note: Depending on which SUB MEAS is chosen, the ON/OFF settings of SPLIT CHand DUAL CH or the status of the marker list, the screen display varies.• Display menu (2 of 2){GRATICULE ON/OFF} : Selects ON/OFF of the coordinate display.* This function cannot be set for the Smith chart or thepolar coordinates.{LABEL} : Calls the label menu for entering the label. (Refer tosub-section 7.4.8.){COLOR} : Specifies the color of the trace and the marker. (Referto sub-section 7.4.9.){DEFAULT COLOR} : Sets all color setting to default.123
