ADTRAN TOTAL ACCESS 600R User Interface Manual

Also see for TOTAL ACCESS 600R: System manual Specifications System manual User Interface Guide

ADTRAN TOTAL ACCESS 600R User Interface Manual Manual pdf 38 page image

Page 38 © 2002, ADTRAN, Inc. 64200600L1#T-31ATotal Access 600R User Interface Guide (UIG)ROUTER >CONFIG >E THERNETUse the ETHERNET menu (Figure 8) to configure the Ethernet port on the 600R.Figure 8. Ethernet MenuROUTER >CONFIG>E THERNET >PRIMARY IPThis is used to setup the IP address for the LAN on the 600R.IP AddressThe IP address assigned to the 600R's Ethernet port is set here. This address must be unique within thenetwork. Default is 10.0.0.1.Subnet MaskThis is the IP network mask that is to be applied to the 600R's Ethernet port. Default is 255.255.255.0.Default GatewayThe default gateway is used by the 600R to send IP packets whose destination address is not found inthe route table. Default is 0.0.0.0.RIPUse this menu to enable RIP on the LAN interface.TCP E STAB Yes - only when TCP establishedNo - only when TCP not establishedIgnore - ignore TCP flags (default)