ADTRAN NetVanta 3458-PoE Hardware Installation Manual

Also see for NetVanta 3120: Quick reference guide Hardware installation guide Quick start guide

Contents

ADTRAN NetVanta 3458-PoE Hardware Installation Manual Manual pdf 23 page image

NetVanta 3000 Series Hardware Installation Guide Physical Descriptions61200860L1-34AA Copyright © 2010 ADTRAN, Inc. 23NetVanta 3130 Rear Panel DesignThe NetVanta 3130 rear panel is shown below. Appendix A on page 101 provides pinouts.Figure 7. NetVanta 3130 (with DBU) Rear Panel LayoutFigure 8. NetVanta 3130 (without DBU) Rear Panel LayoutNetVanta 3130 Rear Panel InterfacesADSL InterfaceThe NetVanta 3130 rear panel has an ADSL port to connect directly to ADSL, ADSL2, or ADSL2+service.DBU Interface (1700610L2 only)The NetVanta 3130 has a DBU port on the rear panel to provide analog, V.90 dial backup.Factory Default SwitchThe NetVanta 3130 has a factory default switch (labeled in Figure 7) on the rear of the unit. If thefactory default switch is pressed during bootup, the unit will stay in bootstrap mode. Since the unit hasno serial port, Telnet has been built into the boot code. The default IP address is 10.10.10.1.The default switch must be pressed WHILE the STAT light is flashing green. Do notpress the default switch BEFORE the STAT light is flashing green, as this will causeboot to be missed.1DBU 2 3 4ADSL1 0DefaultSwitch1 2 3 4ADSL1 0DefaultSwitch