ADLINK Technology cPCI-3615 Series User Manual

Contents

ADLINK Technology cPCI-3615 Series User Manual Manual pdf 76 page image

62 Getting Started5.5 Installing the cPCI-3615 to the ChassisThe cPCI-3615 may only be installed in a system slot of a 3UCompactPCI chassis. These instructions are for reference only.Refer to the user guide that comes with the chassis for more infor-mation.1. Be sure to select the correct slot depending on the oper-ational purpose of the module. The system power maynow be powered on or off.2. Remove the blank face cover from the selected slot, ifnecessary.3. Press down on the release catches of the cPCI-3615ejector handles.4. Remove the black plastic caps securing the mountingscrews to the front panel.5. Align the blade’s top and bottom edges to the chassiscard guides, and then carefully slide the blade into thechassis. A slight resistance may be felt when insertingthe blade. If the resistance it too strong, check if thereare bent pins on the backplane or if the board’s connec-tor pins are not properly aligned with connectors on thebackplane. Then push the board until it is completelyflush with the chassis.6. Push the ejector handle outwards to secure the blade inplace, and then fasten the screws on the front panel.7. Connect the cables and peripherals to the board, andthen turn the chassis on if necessary.