ADEMCO VISTA-128FBP Programming Manual

Also see for VISTA-128FBP: User guide User guide

ADEMCO VISTA-128FBP Programming Manual Manual pdf 32 page image

– 32 –Device ProgrammingThis menu is used to program keypads, receivers, and relay modules, etc.Device Address 00 is always set as an alpha keypad assigned to Partition 1 with no sounder suppressionoptions, and these settings cannot be changed.From Data Field Programming mode, press #93 to display "ZONE PROG?" Press [0] repeatedly to display "DEVICE PROG?"PROMPT EXPLANATIONDEVICE PROG?1=YES 0=NO 0Press [1] to enterDevice Programming.DEVICE ADDRESS01-30, 00=QUIT 01The device address identifies the device to the control. Enter the 2-digit device address number to matchthe device's physical address setting (01-30).Note: Device Address 04 must be used for the 4285/4286 Voice Module, if one is utilized. If not, it can beused for another device type.Press [✱] to accept entry.Select the type of addressable device as follows:00 = device not used 06 = long range radio01 = alpha keypad (6139/6160, AUI) 08 = fire display (FSA)03 = RF receiver (5881) 09 = Vista Gateway Module (VGM)04 = output relay module (4204) 10 = panel link module05 = voice (VIP) Module (4285/4286)DEVICE TYPE00Press [✱] to accept entry.Alpha KeypadPROMPT EXPLANATION01 CONSOLE PART.1If you selected device type 01 (alpha keypad), this prompt appears. Enter the addressable device's defaultpartition number (01 to maximum number of partitions programmed for system in field 2*00). This is theprimary partition for the device. Enter 9 to make this keypad a "Master" keypad for the system.Press [✱] to accept entry.01 SOUND OPTION00If you entered device type 01 (alpha keypad), this prompt appears. Keypads can be individuallyprogrammed to suppress arm/disarm beeps, entry/exit beeps and chime mode beeps. This helps preventunwanted sounds from disturbing users in other areas of the premises.Enter a number 00-03 for the keypad sounding suppression options desired for the keypad as follows:00 = no suppression01 = suppress arm/disarm & entry/exit beeps02 = suppress chime mode beeps only03 = suppress arm/disarm, entry/exit and chime mode beepsPress [✱] to accept entry.01 KEYPAD GLBL?0If you entered device type 01 (alpha keypad), this prompt appears. Each keypad can give users with accessto multiple partitions the ability to arm and disarm those partitions from it. To enable this keypad for globalarming/disarming, enter 1. To prevent the ability to use this keypad for global arming/disarming, enter 0.Press [✱] to accept entry.01 AUI ?1 = YES 0 = NO 0If you selected device type 01 (alpha keypad), this prompt appears. Enter 1 (YES) if the device is an AUI(Symphony 8112, 8122, 8132, or 8142). See the Symphony’s instructions for the installation andoperation.Press [✱] to accept entry.