ADC Gas Electric Steam AD-26 User Manual

Contents

ADC Gas Electric Steam AD-26 User Manual Manual pdf 51 page image

49Location to be viewed/changed.Press “Perm Press” key.Display will read “GdLY,” guard delaytime for 3-seconds and then timeprogrammed. If no change, press “PermPress” key, otherwise press “HI” or “LO”keys and then “Perm Press” key.R. PROGRAM LOCATION 15 (PL15)Anti-Wrinkle TimingSummary: Guard delay time is programmable from 1 to 9 minutes. Guard on time is programmable from1 to 99-seconds.Time IncreaseTime DecreaseTime IncreaseTime DecreasePL15GdLYPerm Press2 HI TempPerm PressLO TempRefer to Section V for instructionson entering program locations.(Wait 3-Seconds)20("Hold In" to Accelerate) ("Hold In" to Accelerate)LO Temp HI TempPerm PressPL16Proceed to next locationto be changedTo exit program mode,open program switch("Hold In" to Accelerate) ("Hold In" to Accelerate)Gont(Wait 3-Seconds)Display will read “Gont” anti-wrinkleon time for 3-seconds and then timeprogrammed. If no changes, press “PermPress” key, otherwise press “HI” or “LO”keys and then “Perm Press” key.